FA-H20 Introduction
The Acudor FA-H20 is an aluminum floor door for H20 loading. The FA-H20 is designed for interior and exterior applications where watertightness IS NOT required
-
Material:
Aluminum door and frame; stainless steel hinges and hardware -
Door:
1/4" aluminum diamond plate reinforced to meet AASHTO specification H 20-44 for traffic loading (16000 lb. wheel load over 10” x 20” area with 30% added for impact) -
Frame:
Angle frame fabricated from aluminum extrusion with an integral 1" anchor flange -
Hinge:
Stainless steel butt hinges with tamperproof stainless steel bolts and nuts -
Opening Device:
Automatic hold open arm with red vinyl grip allows door panel to open to 90 degrees, locking door in open position, and allowing for easy control when closing door panel. Stainless steel compression springs provide lift assistance. Available with electrical actuators, operated by wall mounted push button switch, and remote control -
Standard Latch:
Flush aluminum drop handle, stainless steel slamlock with a fixed inside handle, removable outside handle, and removable threaded plug -
Optional Latches / Locks:
Recessed padlock provision: st/stl slamlock -
Finish:
Mill finish, with bituminous coating on exterior of frame
Floor Doors
Product Downloads
| Product Information | Submittal Drawing | BIM | |
|---|---|---|---|
|
FA-H20
|
|
|
|
Product Highlights
Angle frame construcDesigned for off-street locations that may occasionally receive AASHTO H-20-44 wheel loads
Diamond plate door panel is equipped with a flush aluminum drop handle and an automatic hold open arm
Angle frame construction with integral anchor flange is designed to be cast into concrete
Designed for interior and exterior applications where watertightness IS NOT required
Request Information
Do you have a question regarding our products? Do you need more information for your project?
Please don’t hesitate to reach out, we’re here to help!
