SVG Smoke Vent Introduction
Acudor Smoke Vents are designed to provide an economical solution for fire ventilation by removing deadly smoke, heat, and gases from a burning building. Double leaf Smoke Vents are used for smaller areas that need venting, including elevator shafts and stairwells. Single leaf units are not U.L. Listed.
-
Cover
Double-skin construction (“in box type design”) with 1" cellulose insulation and a continuous EPDM foam weather/draft seal gasket that is attached to the inside of cover to provide a flush, tight fit. Designed to support a live load of 40lbs./sq. ft., the cover is 14 gauge galvanized steel with a 22 gauge galvanized steel inside liner. -
Curb
14 gauge galvanized steel with 1" thick fiberboard roof insulation at curb exterior. Curb is 12" high, with 3.375" wide bottom flange and pre-drilled mounting holes. -
Hinge
Heavy duty galvanized steel / aluminum pintle hinges with 3/8" pin -
Opening
Gas spring operators allow cover to open and close with ease. Inside and outside release allows for manual lid operation. -
Door Latch
Self latching Slam Latch. Supplied standard with 165° UL Listed Fusible Link. Resettable McCabe link available. -
Finish
Galvanized Steel: baked on polyester enamel paint
Roof Hatches & Smoke Vents
Product Downloads
| Product Information | 3D View | BIM | Archicad | |
|---|---|---|---|---|
|
SVG Smoke Vent
|
|
|
|
|
Product Highlights
14 gauge G90 Galvanized Steel
12" high insulated curb
High performance gas springs
Inside and Outside manual release
UL Listed Fusible or McCabe Resettable Link
Request Information
Do you have a question regarding our products? Do you need more information for your project?
Please don’t hesitate to reach out, we’re here to help!
